Body Fat Calculator

A tape measure is all you need — enter your height, neck and waist (plus hip for women) and get an estimated body fat percentage.

Flat vector illustration of a bathroom scale wrapped in a measuring tape
Estimated body fat
—

The quick answer

A man who is 70 inches tall, with a 15-inch neck and a 34-inch waist, has about 17.4% body fat by the US Navy method — in the 'average' band for men. The formula uses the gap between waist and neck, adjusted for height: a bigger gap means more body fat.

It is an estimate, not a scan. The Navy method usually lands within 3–4 percentage points of a DEXA scan when measurements are taken carefully — good enough to track progress over months.

The formula, and two quick examples

Men: 495 ÷ (1.0324 − 0.19077 × log10(waist − neck) + 0.15456 × log10(height)) − 450

For women the formula adds the hip: 495 ÷ (1.29579 − 0.35004 × log10(waist + hip − neck) + 0.22100 × log10(height)) − 450. The Navy equations were fitted in centimetres, so this calculator converts your inches to centimetres first — the maths is the same either way.

Example 1 — man, 70 in tall, neck 15 in, waist 34 in: waist minus neck is 19 in (48.3 cm). The formula gives 17.4% body fat — average for a man.
Example 2 — woman, 64 in tall, neck 12 in, waist 27 in, hip 36 in: waist plus hip minus neck is 51 in (129.5 cm). The formula gives 23.7% body fat — fitness range for a woman.

Body fat categories

The standard Navy ranges. Where you sit matters more than the exact decimal.

CategoryMenWomen
Essential fat2–5%10–13%
Athletes6–13%14–20%
Fitness14–17%21–24%
Average18–24%25–31%
Obese25% and above32% and above

What changes the number most

Waist biggest lever

Each extra inch on the waist, with the same neck, pushes body fat up by roughly 2–3 points.

Neck small lever

A thicker neck lowers the result a little — it is the comparison point for the waist.

Height fine tuning

Taller people get a slightly lower number for the same waist and neck.

Hips (women) part of the sum

For women the hip joins the waist, since fat sits differently.

Easy mistakes to avoid

  • Measuring the waist at the narrowest point. The Navy waist goes at the navel, after a normal breath out — not sucked in, and not at the belt line.
  • Pulling the tape tight. The tape should sit flat on the skin without squeezing. A tight tape can shave an inch off and fake a better result.
  • Treating one reading as final. Measure three times and take the middle value. Tape readings wobble by half an inch easily, and that moves the result.

Tips that actually help

  • Measure in the morning. Before food and water, at the same time each week. That keeps readings comparable over time.
  • Track the trend, not the decimal. A steady fall from 24% to 21% over three months means far more than whether today says 22.9% or 23.4%.
  • Pair it with weight and photos. Body fat, scale weight and a monthly photo together tell the full story — no single number does.

The complete guide

Your weight tells you how heavy you are.

Read: Body Fat Calculator — the Complete Guide →

Frequently asked questions

How accurate is the US Navy body fat method?

Usually within 3–4 percentage points of a DEXA scan when measurements are taken carefully. It is a field estimate, not a lab measurement — good for tracking change over time, not for a medical diagnosis.

Where do I measure my waist for the Navy method?

At the navel (belly button), with the tape level all the way round, after breathing out normally. Do not suck in, and do not pull the tape tight.

Why does the formula need my neck measurement?

The neck is the comparison point: the gap between waist and neck is what the formula really reads. A thick neck with a slim waist means a leaner build, so the result comes out lower.

What is a healthy body fat percentage?

For men, the fitness range is roughly 14–17% and average is 18–24%. For women, fitness is 21–24% and average is 25–31%. Below essential fat (2–5% men, 10–13% women) is not healthy.

Why do women need a hip measurement?

Fat sits differently in women, so the hip measurement goes into the formula alongside the waist. For men the waist and neck are enough.

Does weight matter for this calculator?

No — the Navy method never uses your weight. It works purely from circumferences and height, which is why it is handy when the scale is misleading, for example after building muscle.